WIT Press


Experimental Verification Of Method Of Machine Tool - Cutting Process System Model Reduction In Face Milling

Price

Free (open access)

Paper DOI

10.2495/CMEM990491

Volume

22

Pages

10

Published

1999

Size

946 kb

Author(s)

M. Pajor, K.Marchelek & B.Powalka

Abstract

This article presents the method of vibrostability analysis of nonstationary model of machine tool-cutting process MT-CP system in end milling. The original method of number of freedom reduction of MT-CP model is presented. Results of numerical analysis are compared with results of experimental vibrostability examinations of the chosen milling machine. This allows for the determination of an acceptable simplification level in MT-CP system model. 1 Introduction End milling process creates the most disadvantageous conditions of MT-CP system dynamic load. Methods of computational vibrostabil

Keywords